Daily Rules, Proposed Rules, and Notices of the Federal Government
Section 323 of the Energy Policy and Conservation Act (Act) requires that DOE prescribe test procedures for the measurement of the estimated annual operating costs or other measures of energy consumption for certain consumer products specified in the Act. (42 U.S.C. 6293(b)(3)) These test procedures are found in Title 10 of the Code of Federal Regulations (CFR) part 430, subpart B.
Section 323(b)(3) of the Act requires that the estimated annual operating costs of a covered product be calculated from measurements of energy use in a representative average use cycle or period of use and from representative average unit costs of the energy needed to operate such product during such cycle. (42 U.S.C. 6293(b)(3)) The section further requires that DOE provide information to manufacturers regarding the representative average unit costs of energy. (42 U.S.C. 6293(b)(4)) This cost information should be used by manufacturers to meet their obligations under section 323(c) of the Act. Most notably, these costs are used to comply with Federal Trade Commission (FTC) requirements for labeling. Manufacturers are required to use the revised DOE representative average unit costs when the FTC publishes new ranges of comparability for specific covered products, 16 CFR part 305. Interested parties can also find information covering the FTC labeling requirements at
DOE last published representative average unit costs of residential energy in a
DOE's Energy Information Administration (EIA) has developed the 2010 representative average unit after-tax costs found in this notice. The representative average unit after-tax costs for electricity, natural gas, No. 2 heating oil, and propane are based on simulations used to produce the January, 2010, EIA
The 2010 representative average unit costs under section 323(b)(4) of the Act are set forth in Table 1, and will become effective April 19, 2010. They will remain in effect until further notice.