Daily Rules, Proposed Rules, and Notices of the Federal Government
We must receive comments on this AD by October 26, 2012.
For service information identified in this AD, contact GippsAero, P.O. Box
You may examine the AD docket on the Internet at
The Civil Aviation Safety Authority (CASA), which is the aviation authority for the Commonwealth of Australia, has issued AD AD/GA200/1, dated August 23, 2012 (referred to after this as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:
As a result of a reported case of failure of the strut bolt through the main spar on a GA200C aircraft, GippsAero has issued a mandatory service bulletin to alert operators and maintenance organisations and to provide inspection and rectification actions.
This Airworthiness Directive makes this inspection and rectification action mandatory. Failure to complete the actions required by this service bulletin may result in wing strut bolt failure, resulting in wing structural failure.
GippsAero has issued Mandatory Service Bulletin SB-GA200-2012-08, Issue 1, dated August 22, 2012. The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with this State of Design Authority, they have notified us of the unsafe condition described in the MCAI and service information referenced above. We are issuing this AD because we evaluated all information provided by the State of Design Authority and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design.
An unsafe condition exists that requires the immediate adoption of this AD. The FAA has found that the risk to the flying public justifies waiving notice and comment prior to adoption of this rule because failure to complete the actions required by this service bulletin may result in wing strut bolt failure, resulting in wing structural failure. Therefore, we determined that notice and opportunity for public comment before issuing this AD are impracticable and that good cause exists for making this amendment effective in fewer than 30 days.
This AD is a final rule that involves requirements affecting flight safety, and we did not precede it by notice and opportunity for public comment. We invite you to send any written relevant data, views, or arguments about this AD. Send your comments to an address listed under the
We will post all comments we receive, without change, to
We estimate that this AD will affect 3 products of U.S. registry. We also estimate that it would take about 2 work-hours per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour. Required parts would cost about $0 per product.
Based on these figures, we estimate the cost of the AD on U.S. operators to be $510, or $170 per product.
In addition, we estimate that any necessary follow-on actions would take about 2 work-hours and require parts costing $400 for a cost of $570 per product. We have no way of determining the number of products that may need these actions.
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
(1) Is not a “significant regulatory action” under Executive Order 12866,
(2) Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),
(3) Will not affect intrastate aviation in Alaska, and
(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:
49 U.S.C. 106(g), 40113, 44701.
This airworthiness directive (AD) becomes effective September 14, 2012.
This AD applies to GA200 (Pty) Ltd Models GA200 and GA200C airplanes, all serial numbers, certificated in any category.
Air Transport Association of America (ATA) Code 57: Wings.
This AD was prompted by mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. We are issuing this AD to require actions to address the unsafe condition on these products.
Unless already done, do the following actions.
(1) Within 10 hours time-in-service (TIS) after September 14, 2012 (the effective date of this AD), and repetitively thereafter at intervals not to exceed every 100 hours TIS, do the inspections required following GippsAero Mandatory Service Bulletin SB-GA200-2012-08, Issue 1, dated August 22, 2012.
(2) If you find any discrepancy in any of the inspections required by paragraph (f)(1) of this AD, before further flight, take corrective actions following GippsAero Mandatory Service Bulletin SB-GA200-2012-08, Issue 1, dated August 22, 2012.
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Doug Rudolph, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4059; fax: (816) 329-4090; email:
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.
(3) Reporting Requirements: For any reporting requirement in this AD, a federal agency may not conduct or sponsor, and a person is not required to respond to, nor shall a person be subject to a penalty for failure to comply with a collection of information subject to the requirements of the Paperwork Reduction Act unless that collection of information displays a current valid OMB Control Number. The OMB Control Number for this information collection is 2120-0056. Public reporting for this collection of information is estimated to be approximately 5 minutes per response, including the time for reviewing instructions, completing and reviewing the collection of information. All responses to this collection of information are mandatory. Comments concerning the accuracy of this burden and suggestions for reducing the burden should be directed to the FAA at: 800 Independence Ave. SW., Washington, DC 20591, Attn: Information Collection Clearance Officer, AES-200.
Refer to MCAI Civil Aviation Safety Authority AD AD/GA200/1, dated August 23, 2012, and GippsAero Mandatory Service Bulletin SB-GA200-2012-08, Issue 1, dated August 22, 2012, for related information.
(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.
(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise.
(i) GippsAero Mandatory Service Bulletin SB-GA200-2012-08, Issue 1, dated August 22, 2012.
(3) For GA200 (Pty) Ltd service information identified in this AD, contact GippsAero, PO Box 881, Morwell, Victoria 3840, Australia, telephone: + 61 (0) 3 5172 1200; fax + 61 (0) 3 5172 1201; email:
(4) You may view this service information at FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148.
(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: