Daily Rules, Proposed Rules, and Notices of the Federal Government
For service information identified in this proposed AD, contact Rolls-Royce Deutschland Ltd & Co KG, Eschenweg 11, Dahlewitz, 15827 Blankenfelde-Mahlow, Germany; phone: 49 0 33-7086-1883; fax: 49 0 33-7086-3276. You may view this service information at the FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA. For information on the availability of this material at the FAA, call 781-238-7125.
You may examine the AD docket on the Internet at
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the
We will post all comments we receive, without change, to
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA AD 2012-0163, dated August 28, 2012 (referred to hereinafter as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:
The results of a recent quality review of low pressure turbine (LPT) stage 1 static air seal and high pressure turbine (HPT) stage 1 air seal support bolts identified that, before installation, those bolts may have not been inspected. As a consequence, bolts with reduced material properties may have been installed in some engines.
This condition, if not detected and corrected, could lead to failure of a bolt, potentially causing turbine disc fracture and release of high-energy debris, possibly resulting in damage to the aeroplane and/or injury to the occupants.
RRD has issued Alert Service Bulletin TAY-72-A1696, Revision 1, dated June 11, 2012. The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.
This product has been approved by EASA, and is approved for operation in the United States. Pursuant to our bilateral agreement with the European Community, EASA has notified us of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all information provided by EASA and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design. This proposed AD would require inspection and replacement if necessary, of affected bolts.
Based on the service information, we estimate that this proposed AD would affect about 20 engines installed on
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
1. The authority citation for part 39 continues to read as follows:
49 U.S.C. 106(g), 40113, 44701.
2. The FAA amends § 39.13 by adding the following new AD:
We must receive comments by January 14, 2013.
This AD applies to Rolls-Royce Deutschland Ltd & Co KG (RRD) Tay 611-8 turbofan engines, serial numbers 16245, 16256, 16417, 16418, 16584, 16585, 16639, 16640, 16701, 16702, 16813, 16814, 16853, 16854, 16879, 16880, 16898, 16905, 16906, 16911, 16923, 16935, and 16936, with a date of the last shop visit before December 8, 2006.
This AD was prompted by a recent quality review determination that bolts with reduced material properties may have been installed in some engines. We are issuing this AD to prevent uncontained turbine disc fracture and damage to the airplane.
Unless already done, for engines with a date of the last shop visit before December 8, 2006, do the following actions:
(1) If engine cycles accumulated since the last engine shop visit is 5,400 cycles or more on the effective date of this AD, inspect the bolts installed in the low-pressure turbine (LPT) stage 1 static seal and high-pressure turbine (HPT) stage 1 air seal support within 100 engine cycles-in-service.
(2) If engine cycles accumulated since the last engine shop visit is fewer than 5,400 cycles on the effective date of this AD, inspect the bolts installed in the LPT stage 1 static seal and HPT stage 1 air seal support before accumulating 5,500 engine cycles since the last engine shop visit.
(3) If any broken bolt, brown bolt, or bolt with a rough oxidized surface is identified, then replace all bolts with new bolts before further flight.
(4) Within 30 days after the inspection, report the inspection findings to RRD service engineering. Guidance on reporting can be found in Alert Service Bulletin TAY-72-A1696, Revision 1, dated June 11, 2012.
After the effective date of this AD, do not install any HPT module and/or LPT module into any engine, or any engine onto an airplane, unless the bolts have been inspected and replaced if necessary, as specified in paragraph (e) of this AD.
A federal agency may not conduct or sponsor, and a person is not required to respond to, nor shall a person be subject to a penalty for failure to comply with a collection of information subject to the requirements of the Paperwork Reduction Act unless that collection of information displays a current valid OMB Control Number. The OMB Control Number for this information collection is 2120-0056. Public reporting for this collection of information is estimated to be approximately 5 minutes per response, including the time for reviewing instructions, completing and reviewing the collection of information. All responses to this collection of information are mandatory. Comments concerning the accuracy of this burden and suggestions for reducing the burden should be directed to the FAA at: 800 Independence Ave. SW., Washington, DC 20591, Attn: Information Collection Clearance Officer, AES-200.
The Manager, Engine Certification Office, FAA, may approve AMOCs to this AD. Use the procedures found in 14 CFR 39.19 to make your request.
(1) For more information about this AD, contact Frederick Zink, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; phone: 781-238-7779; fax: 781-238-7199; email:
(2) Refer to European Aviation Safety Agency AD 2012-0163, dated August 28, 2012, and RRD Alert Service Bulletin TAY-72-A1696, Revision 1, dated June 11, 2012, for related information.
(3) For service information identified in this AD, contact Rolls-Royce Deutschland Ltd & Co KG, Eschenweg 11, Dahlewitz, 15827 Blankenfelde-Mahlow, Germany; phone: 49 0 33-7086-1883; fax: 49 0 33-7086-3276. You may view this service information at the FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA. For information on the availability of this material at the FAA, call 781-238-7125.